The Compal LA-6582P (PEW71/81/91) is a workhorse motherboard found in the ubiquitous Acer Aspire 5742, 5733Z, and Gateway NV55C series. Built on the Intel 1st Generation Arrandale platform with the HM55 Express chipset, this board represents a pivotal era in laptop engineering. As a senior technician at geniusmind4u.blogspot.com, I frequently see these boards for common power-rail failures and BIOS corruption. This guide provides the schematic and professional diagnostic steps to resolve no-power and no-display symptoms on this specific platform.
Board Architecture & Technical Specifications
| Motherboard Model / ODM Part Number | Compal LA-6582P (PEW71/81/91) Rev: 0.2 |
| Target Laptop Series / Form Factor | Acer Aspire 5733Z, 5742, 5742G, Gateway NV55C |
| Chipset / CPU Architecture | Intel HM55 PCH / Intel Core i3-i5 Arrandale (PGA988) |
| Super I/O (EC/KBC) Controller | ENE KB926QF-D3 / KB930 |
| Key Voltage Rails & Switching Coils | +3VALW (PL27), +5VALW (PL28), +VCC_CORE (PL24, PL25) |
Real-World Motherboard Diagnostic Procedures
1) DC-IN Protection & Charging Logic Analysis
The LA-6582P uses the ISL88731C (PU1) charging IC. When the adapter is connected, 19V (+19VB) must pass through the dual P-Channel MOSFETs PQ1 and PQ2. If the laptop is dead with 0.00A draw, check for 19V at the drain of PQ2. If missing, verify the ACIN signal (pin 13 of PU1) which should be approximately 3.2V. If ACIN is present but the gates (pin 4) of PQ1/PQ2 are high (19V), the charging IC is in protection mode. Check the current sense resistor PR3 (0.01 ohm) for drift and ensure ACOK is being pulled high to the EC.
2) Standby Power (+3VALW / +5VALW) Generation
The Always-On rails are managed by PU4 (RT8206B). This IC generates +3VALW at PL27 and +5VALW at PL28. On this specific board, a common failure point is the filtering capacitors near the inductors. If you have no standby voltages, check the enable signals ENTRIP1 and ENTRIP2. Note that on this Compal architecture, the +3VALW and +5VALW are required before the power button is pressed to power the ENE KB926QF EC. If PL27 measures short to ground, suspect the EC chip itself or the PCH standby section.
3) Power-On Sequence & Clocking Issues
If the laptop triggers but immediately shuts down, monitor the PM_SLP_S3# and PM_SLP_S5# signals from the HM55 PCH. These signals must transition to high (3.3V) to enable the secondary rails like +1.5V (DDR3) and +VCC_CORE. Because this is a 1st Gen Intel platform, check the Y2 crystal (32.768kHz) near the PCH; if the RTC clock is unstable, the PCH will never release the reset signals. Furthermore, if the fan spins at max speed with no display, the ME Region in the BIOS (UH4) is likely corrupted and requires a clean dump.
Download Schematic File
🔎 Read the chip-level diagnostic notes above while you wait.
Professional Repair Assistance
Explore our technician resources:
- 🛠️ Diagnose No-Power & Short-Circuit faults step-by-step: Interactive Laptop Diagnostic Lab
- 🛒 Original Replacement Motherboards & IC Components: Official Spare Parts Mega Store
No comments:
Post a Comment