The Acer Aspire 5315, 5720, and 7720 series are built on the classic Compal LA-3551P (ICL50) motherboard architecture. This platform belongs to the Intel Santa Rosa era, featuring the Intel GL960 or PM965 Northbridge paired with the ICH8M Southbridge. As a senior engineer, I can tell you that while these boards are aging, they are highly repairable due to the discrete nature of their power ICs and the well-documented signal paths characteristic of Compal designs from this generation.
Board Architecture & Technical Specifications
| Motherboard Model / ODM Part Number | Compal LA-3551P (ICL50/ICL70) |
| Target Laptop Series / Form Factor | Acer Aspire 5315, 5720, 7720, 7320 |
| Chipset / CPU Architecture | Intel Core 2 Duo (Socket P) / GL960 + ICH8M |
| Super I/O (EC/KBC) Controller | ENE KB926QF B1 |
| Key Voltage Rails & Switching Coils | +3VALW (PL10), +5VALW (PL11), +VCC_CORE (PL13, PL14), +1.8VP (PL12) |
Real-World Motherboard Diagnostic Procedures
1) Input Power Stage & DC-IN Protection Circuit
On the LA-3551P, the 19V VIN enters through the DC jack and must pass through the first and second protection MOSFETs, PQ1 and PQ2 (typically AO4407). These are P-Channel MOSFETs controlled by the PU1 (ISL6251) charging IC. If the board is dead, check for 19V at PR3 (the main current sense resistor). If 19V is missing here, verify the PACIN signal. A common failure in this era is the breakdown of ceramic capacitors on the +19VB rail, specifically near the CPU VRM section, which causes the ISL6251 to shut down the gate drive to prevent thermal runaway.
2) Standby Power & Secondary Rail Generation
The Always-On rails (+3VALW and +5VALW) are generated by PU4 (MAX8744). Before pressing the power button, you must measure 3.3V on PL10 and 5V on PL11. If these rails are missing, check the LDO output (Pin 21 of PU4) which should be 5V (+5VLP). A frequent issue on the 5720/5315 models is a short circuit on the +3VALW line caused by a failed Southbridge (ICH8M) or a leaky ENE KB926 EC chip. Normal resistance to ground on PL10 should be in the kilo-ohm range; if it is below 50 ohms, suspect the EC or the PCH.
3) Power-On Sequence & The NEC/TOKIN Stability Issue
Once the power button is pressed, the EC sends MAINON and SYSON to enable the remaining rails. However, the most notorious fault on the LA-3551P involves the NEC/TOKIN (OE128 or OE907) capacitor located directly under the CPU socket. This Proadlizer capacitor filters +VCC_CORE. Over time, its ESR increases, leading to system instability, blue screens, or the laptop failing to boot when the AC adapter is plugged in. The professional fix is to remove the NEC/TOKIN and replace it with four 330uF Tantalum capacitors (2.5V or 4V) to restore clean ripple-free power to the CPU.
Download Schematic File
🔎 Read the chip-level diagnostic notes above while you wait.
Professional Repair Assistance
Explore our technician resources:
- 🛠️ Diagnose No-Power & Short-Circuit faults step-by-step: Interactive Laptop Diagnostic Lab
- 🛒 Original Replacement Motherboards & IC Components: Official Spare Parts Mega Store
No comments:
Post a Comment